26 GTH-4013 SX GTH-4017 SX Document 57.4403.4200Section 2 - Technical Specification May 2008TECHNICAL SPECIFICATIONDISPLAY FUNCTION0 The LED bar indicates the type of machine in use:1 LED on -GTH 4013 SX - GTH 4017 SXTo select the machine to be calibrated press to increase the number of LED's lit orpress to reduce the number of LED's lit.If you are doing the first calibration, press to reset the system and load the defaultparameters of the selected machine.If you are re-calibrating the instrument, directly jump to point 1.Press to proceed to the next point (1).1 Lower the outriggers to the ground, fully retract the boom holding it slightly above thehorizontal with respect to the ground. DON’T lift loads.Press to confirm the EMPTY calibration of the machine. The audible alarm will soundto confirm the command has been executed.Press to proceed to the next point (2).2 With outriggers down, place a load on the forks with a known weight, extend the boomwhile holding it horizontal till reaching the overturning moment. The overturning distanceis from the front part of the wheels to the center of the load. (see the diagram inside thecab).Press to confirm the LOADED calibration of the machine and check that the alarmtriggers. The audible alarm will sound to confirm the command has been executed. Movethe boom fully in while holding the same in the horizontal position.Press to proceed to the next point (3).3 With outriggers down, place a load on the forks with a known weight, extend the boomwhile holding it horizontal till reaching the overturning moment. The overturning distanceis from the front part of the wheels to the center of the load. (see the diagram inside thecab).Press some times to switch off the LED's of the load and press to switch onthem; at the end, all LED's are on from left to right, except the red last one.The procedure is saved automaticallyPress some times to arrive to the point (F).F Press to exit calibration and to SAVE the changes made (the audible alarm soundsand the LED’s come on to confirm that data have been saved).The limiter is no longer in the calibration mode. The LED is not lit fixed any more.You should turn the machine off and then on again to eliminate any alarm messages.Starting to work.Courtesy of Crane.Market
