Section 4 • Repair ProceduresJune 2005Part No. 52075 TMZ-34/19 4 - 1Repair ProceduresAbout This SectionMost of the procedures in this section should onlybe performed by a trained service professionalin a suitably equipped workshop. Select theappropriate repair procedure after troubleshootingthe problem. Perform disassembly procedures tothe point where repairs can be completed. Then tore-assemble, perform the disassembly steps inreverse order.Symbols LegendSafety alert symbol—used to alertpersonnel to potential personalinjury hazards. Obey all safetymessages that follow this symbolto avoid possible injury or death.Red—used to indicate thepresence of an imminentlyhazardous situation which, if notavoided, will result in death orserious injury.Orange—used to indicate thepresence of a potentiallyhazardous situation which, if notavoided, could result in death orserious injury.Yellow with safety alert symbol—used to indicate the presence of apotentially hazardous situationwhich, if not avoided, may causeminor or moderate injury.Yellow without safety alertsymbol—used to indicate thepresence of a potentiallyhazardous situation which, if notavoided, may result in propertydamage.Green—used to indicate operationor maintenance information.Indicates that a specific result is expected afterperforming a series of steps.Indicates that an incorrect result has occurredafter performing a series of steps.Observe and Obey:Repair procedures shall be completed by aperson trained and qualified on the repair of thismachine.Immediately tag and remove from service adamaged or malfunctioning machine.Repair any machine damage or malfunctionbefore operating the machine.Before Repairs Start:Read, understand and obey the safety rulesand operating instructions in the GenieTMZ-34/19 Operator's Manual.Be sure that all necessary tools and parts areavailable and ready for use.Read each procedure completely and adhereto the instructions. Attempting shortcuts mayproduce hazardous conditions.Unless otherwise specified, perform eachrepair procedure with the machine in thefollowing configuration:· Machine disconnected from tow vehicle· Machine parked on a firm, level surface withthe boom stowed and both latches secured· Key switch in the off position with thekey removed· The red Emergency Stop button in the offposition at both ground and platform controls· Wheels chocked and parking brake applied· All external AC power supply disconnectedfrom the machine800-610-4101ActionRental.com
