REV BSection 4 • Repair Procedures June 20054 - 46 TMZ-34/19 Part No. 52075Axle Components9-1AxleHow to Remove the Axle1 Lower the outriggers and adjust to level themachine and raise the wheels off the ground.2 Disconnect the parking brake cable at thetension equalizer.3 Pull the parking brake cable through themounting hole on the trailer.4 Tag, disconnect and plug the brake line fromthe back of the hub. Cap the fitting.5 Clean up any brake fluid that may have spilled.6 Repeat steps 2 through 5 for the other side.7 Support and secure the axle assembly to anappropriate lifting device.8 Remove the axle mounting fasteners andremove the axle from the machine.Crushing hazard. The axle couldbecome unbalanced and fall if notproperly supported and securedwhen removed from the machine.When the axle is installed, thebrakes should be bled. Refer tothe appropriate brakemanufacturer's manual that wasshipped with your Genie TMZ.9-2Hub and BearingsHow to Remove the Hub andBearingsRepair procedures and additional axle informationare available in the Dexter AxleOperation Maintenance Service Manual(Dexter part number LIT-001-00).Dexter Axle Operation Maintenance Service ManualGenie part number 84376800-610-4101ActionRental.com
