REV BSection 4 • Repair ProceduresJune 2005Part No. 52075 TMZ-34/19 4 - 49Models with hydraulic outriggers:1 Attach a lifting strap from an overhead crane tothe pad end of the outrigger. Do not apply anylifting pressure.2 Tag and disconnect the wire harness from theoutrigger limit switch.3 Remove the pin retaining fasteners from theoutrigger pivot pin. Do not remove the pin.4 Remove the pin retaining fasteners from theoutrigger cylinder rod-end pivot pin.5 Place a rod through the hole in the outriggercylinder rod-end pivot pin and twist to removethe pin. Remove the outrigger cylinder rod-endpivot pin from the machine.6 Secure the rod-end of the cylinder to thechassis.7 Place a rod through the hole in the outriggerpivot pin and twist to remove the pin. Removethe outrigger pivot pin from the machine.Crushing hazard. The outriggercould fall if not properly supportedwhen the pivot pin is removedfrom the machine.Crushing hazard. The outriggercylinder could fall if not properlysupported when the outrigger isremoved from the machine.11-2Outrigger CylinderHow to Remove an OutriggerCylinderWhen removing a hose assemblyor fitting, the O-ring on the fittingand/or hose end must be replacedand then torqued to specificationduring installation. Refer toSection 2, Hydraulic Hose andFitting Torque Specifications.1 Extend the outrigger until the pad just touchesthe ground. Do not rest the weight of themachine on the outrigger.2 Remove the cylinder guard mounting fastenersfrom the rod end of the outrigger cylinder andremove the cylinder guard from the machine.3 Tag and disconnect the wire harness from theoutrigger cylinder valve coil.4 Tag, disconnect and plug the hydraulic hosesfrom the outrigger cylinder. Cap the fittings onthe cylinder.Bodily injury hazard. Sprayinghydraulic oil can penetrate andburn skin. Loosen hydraulicconnections very slowly to allowthe oil pressure to dissipategradually. Do not allow oil to squirtor spray.OUTRIGGER COMPONENTS800-610-4101ActionRental.com
