1-10To do… Use the command… RemarksEnter system view system-view —Enter Layer 2 aggregateinterface viewinterface bridge-aggregationinterface-number —Configure the loadsharing mode for theaggregation grouplink-aggregation load-sharing mode{ destination-ip | destination-mac |source-ip | source-mac } *RequiredBy default, the loadsharing mode of anaggregation group is theglobal load sharing mode.After you configure thiscommand, the loadsharing modes in currentlink aggregation groupchange accordingly.Displaying and Maintaining Link AggregationTo do... Use the command... RemarksDisplay the local system ID display lacp system-id Available in any viewDisplay the global oraggregation group-specific loadsharing modedisplay link-aggregationload-sharing mode [ interface[ bridge-aggregationinterface-number ] ]Available in any viewDisplay link aggregation detailsof portsdisplay link-aggregationmember-port [ interface-typeinterface-number [ to interface-typeinterface-number ] ]Available in any viewDisplay the summaryinformation of all aggregationgroupsdisplay link-aggregationsummary Available in any viewDisplay detailed information ofaggregation groupsdisplay link-aggregation verbose[ bridge-aggregation[ interface-number ] ]Available in any viewClear the LACP statistics ofportsreset lacp statistics [ interfaceinterface-type interface-number [ tointerface-type interface-number ] ]Available in user viewClear the statistics of thespecified aggregate interfacesreset counters interface[ bridge-aggregation[ interface-number ] ]Available in user viewLink Aggregation Configuration ExamplesLayer 2 Static Aggregation Configuration ExampleNetwork requirementsAs shown in Figure 1-1, Device A and Device B are connected through their respective Ethernet portsGigabitEthernet1/0/1 to GigabitEthernet1/0/3.
