1-3To do… Use the command… RemarksConfigure HABP to work inserver mode habp server vlan vlan-id RequiredHABP works in client mode by default.Set the interval to sendHABP requests habp timer interval Optional20 seconds by defaultConfiguring an HABP ClientConfigure the HABP client function on each device that is attached to the administrative device andneeds to be managed. As the HABP client function is enabled by default, this configuration task isoptional.Follow these steps to configure an HABP client:To do… Use the command… RemarksEnter system view system-view —Enable HABP habp enable OptionalEnabled by defaultConfigure HABP to work inclient mode undo habp server OptionalHABP works in client mode by default.Displaying and Maintaining HABPTo do… Use the command… RemarksDisplay HABP configurationinformation display habp Available in any viewDisplay HABP MAC addresstable entries display habp table Available in any viewDisplay HABP packet statistics display habp traffic Available in any viewHABP Configuration ExampleNetwork requirementsSwitch A is the administrative device and connects two access devices: Switch B and Switch C.Configure HABP so that Switch A can manage Switch B and Switch C.z Configure Switch A as the HABP server, allowing HABP packets to be transmitted in VLAN 2.z Enable HABP client on Switch B and Switch C.z On switch A, set the interval to send HABP request packets to 50 seconds.
