1-4z Extended power-via-MDI TLV, which carries the information about the power supply capability ofthe current device.z Hardware revision TLV, which carries the hardware version of an MED device.z Firmware revision TLV, which carries the firmware version of an MED device.z Software revision TLV, which carries the software version of an MED device.z Serial number TLV, which carries the serial number of an MED device.z Manufacturer name TLV, which carries the manufacturer name of an MED device.z Model name TLV, which carries the model of an MED device.z Asset ID TLV, which carries the asset ID of an MED device. Asset ID is used for directorymanagement and asset tracking.z Location identification TLV, which carries the location identification of a device. Locationidentification can be used in location-based applications.For detailed information about LLDP TLV, refer to IEEE 802.1AB-2005 and ANSI/TIA-1057.Protocols and Standardsz IEEE 802.1AB-2005, Station and Media Access Control Connectivity Discoveryz ANSI/TIA-1057, Link Layer Discovery Protocol for Media Endpoint DevicesLLDP Configuration Task ListComplete these tasks to configure LLDP:Task RemarksEnabling LLDP RequiredSetting LLDP Operating Mode OptionalConfiguring LLDPDU TLVs OptionalEnable LLDP Polling OptionalBasic LLDPconfigurationConfiguring the Parameters Concerning LLDPDU Sending OptionalConfiguring the Encapsulation Format for LLDPDUs OptionalConfiguring the Encapsulation Format of the Management Address OptionalConfiguring CDP Compatibility OptionalConfiguring LLDP Trapping OptionalPerforming Basic LLDP ConfigurationEnabling LLDPFollow these steps to enable LLDP:
