172 SETTING A FREQUENCY Using the tuning dialq Rotate the desired band’s [DIAL] to set the frequency.• If VFO mode is not selected, push the same band’s[V/MHz•SCAN] to select VFO mode.• The frequency changes in the selected tuning steps. (p. ??)wTo change the frequency in 1 MHz (10 MHz for some versions)steps, push [V/MHz•SCAN], then rotate [DIAL].• Pushing and holding [V/MHz•SCAN] for 1 sec. starts scan func-tion. If scan starts, push [V/MHz•SCAN] again to cancel it. Using the [Y]/[Z] keys➥ Push [Y] or [Z] to select the desired frequency.• Push [BAND] to select the desired band (left or right)as the main band in advance.• Pushing and holding [Y]/[Z] for 1 sec. activates ascan. If scan starts, push [Y]/[Z] or [ CLR A(MW)] tocancel it. Using the keypadThe frequency can be directly set via numeral keys on the mi-crophone.z Push [BAND] to select the desired band (left orright) as the main band.• Push [VFO/LOCK] to select VFO mode, if necessary.x Push [ ENT C(T-OFF)] to activate the keypad fordigit input.c Push 6 keys to input a frequency.• When a digit is mistakenly input, push [ENT C(T-OFF)]to clear the input, then repeat input from the 1st digit.• Pushing [CLR A(MW)] clears input digits and retrievesthe frequency.PushPushPushPush[EXAMPLE]: Setting frequency to 145.3625 MHz.ENTCYZWhile 1 MHz tuning step is selected,the digit below 100kHz disappear.While 10 MHz tuning step is selected,the digit below 1 MHz disappear.[V/MHz•SCAN][DIAL]
