527SCAN OPERATION12345678910111213141516171819 Scan edges programmingScan edges can be programmed in the same manner asmemory channels. Scan edges are programmed into scanedges, 1A/1B to 9A/9B, in memory channels.q Set the edge frequency of the desired frequency range inVFO mode:➥ Set the frequency using the desired band’s [DIAL].➥ Set other data (e.g. repeater settings, etc.) if desired.w Push the same band’s [M/CALL•MW] for 1 sec.• “X” indicator and channel number blink.e Rotate the [DIAL] to select one of scan edge channel, 1Ato 9A.r Push the [M/CALL•MW] for 1 sec. to program.• 3 beeps sound and VFO is automatically selected.• Scan edge 1B to 9B is automatically selected when continuing topush the [M/CALL•MW] after programming.t To program a frequency for the other pair of scan edges,1B to 9B, repeat steps q and r.• If the same frequency is programmed into a pair of scan edges,programmed scan will not function.[EXAMPLE]: Programming 145.300 MHz into scan edges 1A.Push to select VFO mode. Rotate for setting frequency, etc. Push for 1 sec.Rotate Push (Left band's) for 1 sec. and continue to push ➠Beep“V/MHzSCANM/CALLMWM/CALLMWBANDMAINBANDMAINBeepBeepBeep“““““BeepBeep“““““
