668 MEMORY/CALL CHANNELS Memory channel programmingq Push [VFO] to select VFO mode.w Set the desired frequency:➥ Select the desired band with [BAND].➥ Set the desired frequency with [DIAL].➥ Or set the desired frequency with keypad directly.In this case, the band and frequency settings with[BAND] and [DIAL] as above are not required.➥ Set other data (e.g. offset frequency, duplex direction,tone squelch, etc.), if desired.ePush and hold [S.MW](MR) for 1 sec. to enter select mem-ory write mode.• 1 short and 1 long beep sound.• “μμ ” indicator blinks.r Rotate [DIAL] to select the desired channel.• Call channels (C0, C1), VFO (VFO) and scan edge channels(0A/0B to 24A/24B), as well as regular memory channels, canbe programmed in this way.t Push and hold [S.MW](MR) for 1 sec. to program.• 3 beeps sound.• Memory channel number automatically increases when contin-uing to push and hold [S.MW](MR) for 3 sec. after programming.[EXAMPLE]: Programming 145.870 MHz into memory chan-nel 11 (blank channel).[DIAL]145 000BANKBANK :----:----MNAME:MNAME:SKIPSKIP :OFF:OFFFMFMr μ 000BANKBANK :----:----MNAME:MNAME:SKIPSKIP :OFF:OFFr μ 011AFMFM145 870PSKIPPSKIPAFMFM145 870PSKIPPSKIPAμFMFM145 870PSKIPPSKIP011VFO modeEnter select memorywrite mode.Rotate [DIAL] to selectchannel 11.Pushfor 1 sec.Channel 11Push and holdfor 1 sec. to program.Return to the VFO mode.
