759SCAN OPERATION12345678910111213141516171819 Full/band/programmed scanq Push [VFO] to select VFO mode.• Select the desired frequency band with [BAND], if desired.w Set the squelch level.eWhile pushing and holding [SCAN](2), rotate [DIAL] to se-lect the desired scanning type.• “ALL” for full scan; “BAND” for band scan, “PROG-xx (or scanname if programmed)” for programmed scan (xx= 0 to 24; pro-grammed scan edges numbers are only displayed), “DUP” (ap-pears only when duplex operation is set) for duplex scan.r To start the scan, release [SCAN](2).• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction, or resumesmanually.• Push [VFO] to stop the scan.About the scanning steps: The selected tuning step ineach frequency band (in VFO mode) is used during scan.Duplex scan function: Repeatedly scans two frequencies(transmission/reception) during duplex scan operation.FMFMA 148 800 FMFMAP SKIPSKIP P SKIPSKIPP01P01148 800• During full/band scan • During programmed scanFMFMA 145 000SCAN:ALLFMA 148 800SCAN:BANDFMA 148 800SCAN:PROG-01P SKIPSKIPP SKIPSKIPP SKIPSKIP• Full scan selection• Programmed scan selection• Band scan selectionSelectable between “ 00” to “24”if programmed.[DIAL]FMFMA 148 800P SKIPSKIPP01P01FMFMA 148 800P SKIPSKIPSCAN:SCANNAMEScan nameScan name is not displayed during a programmed scan.Scan edge numberScan name selection
