Icom IC-E91 Instruction Manual

Also see for IC-E91: Instruction manual Service manual

Contents

809 SCAN OPERATIONtPush and hold [S.MW](MR) for 1 sec. to store the skip con-dition into the memory.• “SKIP” or “P SKIP” indicator appears, according to the skip se-lection in the step r.✔ CONVENIENT!The the skip setting can be set with the following operation.qSelect the desired memory channel to be set as a skipchannel/frequency.wWhile pushing [SKIP](5), rotate [DIAL] to select the skip con-dition from “P SKIP,” “SKIP” and “OFF (no indication).”✔ CONVENIENT!During VFO scanning, such as programmed scan, the skipsetting can be programmed into the highest blank memorychannel which is automatically selected with the following op-eration.q Start the VFO scan.➥ Push [VFO] to select VFO mode.• Select the desired frequency band with [BAND], if desired.➥ Set the squelch level.➥ While pushing and holding [SCAN](2), rotate [DIAL] toselect the desired scanning type.• “ALL” for full scan; “BAND” for band scan, “PROG-xx (or scanname if programmed)” for programmed scan (xx= 0 to 24;programmed scan edges numbers are only displayed), “DUP”for duplex scan.➥ To start the scan, release [SCAN](2).• Scan pauses when a signal is received.• Rotate [DIAL] to change the scanning direction, or resumesmanually.wWhen scan pauses and you want to set the paused fre-quency as a skip frequency.➥ Push and hold [SKIP](5) for 1 sec. to store the pausedfrequency into the highest blank memory channel.• While pushing and holding [SKIP](5), rotate [DIAL] to select askip condition from “SKIP,” “P SKIP” and “OFF.”• While pushing and holding [SKIP](5), scan pauses; and afterwriting the frequency, scan resumes.FMFMAμ SKIPSKIP033033145 700 FMFMAμ P SKIPSKIP033033145 700• Skip channel setting • Program skip setting“SKIP” appears “P SKIP” appears