Kenwood KRF-X9992D Connection And Setup Manual

Also see for KRF-X9992D: User guide Service manual

Contents

15Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992DConnectionsConnecting Your Primary CD Player, continuedDo not plug in the receiver to AC power until youhave connected all your devices.This section focuses on the connections from your200-Disc CD Changer to the KRF-X9992D. Pleaserefer to your changer’s instructions for more detailabout its connection jacks and capabilities.Each set of instructions in this section shows one ofseveral possible variations on connecting your CDplayer(s). For further assistance on optional configu-rations, contact the store where you purchased yourCD player(s).The illustration shows a Kenwood 200-Disc CDChanger. Your CD player may look different.Kenwood DPF-J9010 contains two CD transports.You must connect it as though they were two CDplayers.What if I Have a Video CD-CompatibleCD Player?Connect the audio and video cables from the CDplayer to any unused Video jack set.Do not connect the system control cable in thisinstance.To Connect a Kenwood 200-Disc CDChanger:1. Connect the audio cables from the 200-DiscChanger to the receiver’s CD1 jacks.If you have a Kenwood DPF-J9010, connectOutput A to the receiver’s CD1 jacks and OutputB to the receiver’s CD2/Tape2 Monitor PLAY INjacks as shown to the left.2. Connect the optical digital cable from thechanger to the receiver’s CD1 OPTICAL jack asshown to the left.3. Connect the system control cable from thechanger to the SYSTEM CONTROL jack as shownto the left.Be sure that the SL16/XS8 switch on both thechanger and the receiver is set to SL16.If you are connecting more than one Kenwooddevice with a system control cable, see “What if IHave Several Kenwood Devices (System ControlChaining)?” on page␣ 30 for more information.4. Connect the SL16 text cable (communicationcable) from the changer to the receiver’s SL16TEXT jack as shown to the left.5. Go to “Noting Your Devices” on page␣ 3 and notewhich jacks you used to connect your CDchanger. In addition, note the brand name andmodel number of the CD Changer.To Connect Any Other Primary CDPlayer or Changer:1. Connect the audio cables from the CD player’saudio jacks to the receiver’s CD1 jack set asshown to the left.2. Connect the optical digital cable from the CDplayer’s digital jack to the receiver’s CD1 OPTI-CAL jack as shown to the left.3. If you are connecting a Kenwood CD Player withsystem control, connect the system control cablefrom the CD player to the system control jack asshown to the left.Be sure that the SL16/XS8 switch on both theplayer/changer and the receiver is set appropri-ately.If you are connecting more than one Kenwooddevice with a system control cable, see “What if IHave Several Kenwood Devices (System ControlChaining)?” on page␣ 30 for more information.4. Go to “Noting Your Devices” on page␣ 3 and notewhich jacks you used to connect your CD player/changer. In addition, note the brand name andmodel number of the CD player or changer.To Connect a Secondary CD Player:See “Connecting Your Secondary CD Player or TapeDeck” on page␣ 22.