Kenwood KRF-X9992D Connection And Setup Manual

Also see for KRF-X9992D: User guide Service manual

Contents

27Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992DConnectionsConnecting Your Laser Disc Player (without AC-3 RF Output), continuedDo not plug in the receiver to AC power until youhave connected all your devices.These instructions describe how to connect a laserdisc player with a PCM Digital Output. If yourplayer has a Dolby Digital (AC-3) RF Out, see“Connecting Your Laser Disc Player (with AC-3 RFOutput)” on page␣ 24. This configuration does notallow Dolby Digital laser discs to be played. Pleaserefer to your laser disc player’s instructions for moredetail about its connection jacks and capabilities.The instructions in this section show one of severalpossible variations on connecting your laser discplayer. For further assistance on optional configura-tions, contact the store where you purchased yourreceiver.To Connect a PCM Digital Output LaserDisc Player:1. Review the information under “Before YouBegin” on page␣ 1. It contains important notesabout the types of video connections you canmake.2. Look at the digital connection on your laser discplayer. Use the table below to choose a jack set:Note that the jack sets are linked, even thoughthey are not adjacent. You must connect all ofthe cables from your laser disc player to a linkedjack set. If you connect the analog cables toVIDEO2 and the digital optical cable toVIDEO4,␣ your laser disc player will not workcorrectly.3. Connect the audio cables from the laser discplayer’s Audio OUT jacks to the receiver’s AUDIOjacks as shown to the left.4. Connect the video cable from the laser discplayer’s Video OUT jack to the receiver’s VIDEOPLAY IN jack as shown to the left.5. Connect the digital cable (either coaxial oroptical) from the laser disc player’s digital jack tothe appropriate digital jack on the receiver asshown to the left. Your laser disc player supportsonly one of the digital connection methods—donot connect both.If you use the optical digital cable, be sure toremove the protective cover from the optical jackbefore connecting.6. Go to “Noting Your Devices” on page␣ 3 and notewhich jacks you used to connect your laser discplayer. In addition, note the brand name andmodel number of the laser disc player.optical VIDEO4coaxial VIDEO2 or 3If your digitalcable is...Choose this jackset...