Kenwood KRF-X9992D Connection And Setup Manual

Also see for KRF-X9992D: User guide Service manual

Contents

23Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992DConnectionsConnecting Your Secondary CD Player or Tape Deck, continuedDo not plug in the receiver to AC power until youhave connected all your devices.This section focuses on the connections from yourCD player or tape deck to the KRF-X9992D. Pleaserefer to your CD player or tape deck’s instructionsfor more detail about its connection jacks andcapabilities.Each set of instructions in this section shows one ofseveral possible variations on connecting your CDplayer or tape deck. For further assistance onoptional configurations, contact the store where youpurchased your CD player or tape deck.Do not connect a system control cable from anyunit connected via the CD2/TAPE2 MONITOR jacks.To Connect a Secondary CD Player:1. Connect the audio cables from the CD player’saudio jacks to the receiver’s CD2/TAPE 2 MONI-TOR PLAY IN jack set as shown to the left.Do not connect the system control cable fromthe second CD player, even if it supports systemcontrol.2. Go to “Noting Your Devices” on page␣ 3 and notewhich jacks you used to connect your CD player.In addition, note the brand name and modelnumber of the CD player.If you connect a second tape deck, you cannotconnect a second CD player.To Connect a Secondary Tape Deck:1. Connect the audio cable from the tape deck’sPlay OUT jacks to the receiver’s CD2/TAPE 2MONITOR PLAY IN jacks.2. Connect the audio cable from the tape deck’s RecIN jacks to the receiver’s CD2/TAPE 2 MONITORREC OUT jacks.Do not connect the system control cable fromthe second tape deck, even if it supports systemcontrol.3. Go to “Noting Your Devices” on page␣ 3 and notewhich jacks you used to connect your tape deck.In addition, note the brand name and modelnumber of the tape deck.If you connect a second CD player, you cannotconnect a second tape deck.