31Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992DConnectionsConnecting the AntennasAM Loop AntennaYour new receiver comes with an AM loop antennafor AM radio reception. To connect the AM antenna:1. Insert the antenna loop into the base andposition the loop.2. Open the receiver’s antenna terminal levers.3. Insert the antenna’s wires into the terminal asshown above.4. Close the antenna terminal levers to lock thewires in place.5. Adjust the antenna loop as necessary to improvereception.To prevent hum interference, keep the AM antennawires away from speaker wires, AC power cords, theTV chassis, and the receiver.FM Indoor AntennaYour new receiver also comes with an FM indoorantenna for FM radio reception. To connect the FMantenna:1. Attach the antenna sheath to the pole in thecenter of the receiver’s FM antenna jack, asshown above. When you attach the sheath for thefirst time, you may need to exert quite a bit ofpressure.2. Adjust the antenna as necessary to improvereception.3. Tack the looped end of the antenna in thelocation that provides the best reception.FM Outdoor AntennaKenwood recommends a permanently installedoutdoor FM antenna for best FM reception. Toconnect an outdoor FM antenna:1. Connect the antenna wire to a standard,commercially available antenna adapter asshown above.2. Connect the adapter to the receiver’s FM antennajack.What if I Have Cable Radio?If you have cable radio, contact your cable providerfor assistance with connecting to the KRF-X9992D.
