CHARACTER ENTRYWhile in the character entry screen, you can use the following two methods to enterthe characters:o Pressing the [J]/[K] buttonsPress [J]/[K] to cycle the characters from A ~ Z, a ~ z, 0 ~ 9, and a space (defaultsettings).You can also assign a character to an optional button and later press that button torecall the assigned character: A ~ Z, a ~ z, 0 ~ 9, or a space and characters.● You can enter characters using the [J]/[K] buttons when the buttons function as characterinput buttons. When the buttons function as line up/ down buttons, it is not possible to entera character.o Using the keypad(Full button model Portable transceivers and Mobile transceivers withmicrophone with keypad only)Press the keypad buttons to enter characters as shown in the table below.You can press the [ ] button repeatedly to switch the input mode (upper case B lowercase B numbers B back to beginning).Keypad Character Cycle (Upper Case) Character Cycle (Lower Case)1 @ # " ( ) ! $ _ @ # " ( ) ! $ _2 A B C a b c3 D E F d e f4 G H I g h i5 J K L j k l6 M N O m n o7 P Q R S p q r s8 T U V t u v9 W X Y Z w x y z0 (space) . , ? / ' & (space) . , ? / ' &20