FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTIONFleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned byJVC KENWOOD Corporation. FleetSync enables a variety of paging functions onyour transceiver, some of which depend on dealer programming.Note:● This function is available only in analog operation.SELCALL (SELECTIVE CALLING)A Selcall is a voice call to a station or group of stations.o Transmitting1 Select your desired zone and channel.2 Press the button programmed as [Individual]/ [Individual + Status]/[Individual + Short Message]/ [Group]/ [Group + Status]/ [Group + ShortMessage] to enter Selcall Mode.Alternatively, press the button programmed as [Menu] to enter Selcall Mode usingIndividual/ Individual + Status/ Individual + Short Message/ Group/ Group + Status/ Group+ Short Message in the Menu Mode.3 Press the [J] and [K] buttons to select the station you want to call.● If Manual Dialing is enabled, you can enter the station ID by using the keypad on a fullbutton model Portable transceiver or on the microphone of a Mobile transceiver.4 Press the PTT switch and begin your conversation.o ReceivingAn alert tone will sound and the transceiver will enter Selcall mode. The callingstation’s ID will appear when a Selcall is received. You can respond to the call bypressing the PTT switch and speaking into the microphone.o Identification CodesAn ID code is a combination of a 3-digit Fleet number and a 4-digit ID number. Eachtransceiver has its own ID.● Enter a Fleet number (100 ~ 349) to make a fleet call.● Enter an ID number (1000 ~ 4999) to make an individual call in your fleet.● Enter a Group ID (which is programmed in the FPU) to make a group call.● Enter a Fleet number followed by an ID number to make an individual call in your desiredfleet (Inter-fleet call).● Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).● Select “ALL” Fleet and enter an ID number to make a call to the selected ID in all fleets(Supervisor call).47