Kenwood NX-3000 Series User Manual

Also see for NX-3000 series: User guide User guide User guide User manual User guide

5-TONE SIGNALING (For E type only)5-tone Signaling is enabled or disabled by your dealer. This function opens thesquelch only when the transceiver receives the 5 tones programmed in yourtransceiver. Transceivers that do not transmit the correct tones will not be heard.SELCALL (SELECTIVE CALLING)A Selcall is a voice call to a station or group of stations.o Transmitting1 Select your desired zone and channel.2 Press the button programmed as [Individual]/ [Individual + Status]/[Individual + Short Message]/ [Group]/ [Group + Status]/ [Group + ShortMessage] to enter Selcall Mode.Alternatively, press the button programmed as [Menu] to enter Selcall Mode usingIndividual/ Individual + Status/ Individual + Short Message/ Group/ Group + Status/ Group+ Short Message in the Menu Mode.3 Press the [J] and [K] buttons to select the station you want to call.● If Manual Dialing is enabled, you can enter the station ID by using the keypad on a fullbutton model Portable transceiver or on the microphone of a Mobile transceiver.4 Press the button programmed as [Call 1] to [Call 6] and begin your conversation.Note:● You can also use the buttons programmed as [Digit 1x Down], [Digit 1x Up], [Digit 10xDown], and [Digit 10x Up] to adjust the Selcall number. [Digit 1x Up] and [Digit 1xDown] increases and decreases the Selcall number by 1 respectively each time the buttonis pressed. [Digit 10x Up] and [Digit 10x Down] increases and decreases the Selcallnumber by 10 respectively each time the button is pressed.o ReceivingWhen a call containing the correct tones is received, the transceiver will enter Selcallmode. An alert tone will sound and the calling station’s ID appears on the display.Press any button to return to normal operation.STATUS MESSAGEYou can send and receive Status messages which may be decided in your talk group.Messages can contain up to 16 alphanumeric characters.A maximum of 250 received messages can be stored in the stack memory of yourtransceiver.o Transmitting1 Select your desired zone and channel.2 Press the button programmed as [Status] to enter Status mode (proceed to step5), or [Individual + Status]/ [Group + Status] to enter Selcall mode (proceedto step 3).50