Kenwood NX-3000 Series User Manual

Also see for NX-3000 series: User guide User guide User guide User manual User guide

SCAN REVERTThe Scan Revert channel is the channel selected when you press the PTT switch totransmit during scan. Your dealer can program one of the following Scan Revertchannels:● Selected: The last channel selected is assigned as the new revert channel.● Selected + Talkback: If the channel has been changed, the newly selected channel isassigned as the new revert channel. The transceiver “talks back” on the current channel.● Priority 1/ Priority 2: If your dealer has programmed a Priority channel (either Priority 1 orPriority 2), this channel is the revert zone and channel.● Priority 1 + Talkback/ Priority 2 + Talkback: If your dealer has programmed a Prioritychannel (either Priority 1 or Priority 2), this channel is the revert zone and channel. Thetransceiver “talks back” on the current receive channel.● Last Called + Selected: The last channel on which you received a call is assigned as thenew revert channel. The transceiver “talks back” on the current channel. If the channel hasbeen changed, the newly selected channel is assigned as the new revert channel.SCAN PROGRAMMINGNote:● Scan programming is only available when Scan Type has been set to “List”.o Scan List EditingYou can reprogram your scan list to add or delete any zones or channels.1 Select the channel where the scan list to be edited has been set, press the buttonprogrammed as [Scan Program] to enter Scan Program Mode.Alternatively, press the button programmed as [Menu] to enter Scan Program Mode usingthe Menu Mode.2 Press the [H] and [I] buttons to select the zone or the [J] and [K] buttons to selectthe channel you will add to or remove from the scan list.3 Press the [ ] or [ ] button to confirm your selection.● The indicator appears on the display when a zone is added to the scan list, anddisappears when a zone is removed from the scan list.● The indicator appears on the display when a channel is added to the scan list, anddisappears when a channel is removed from the scan list.4 Press the [ ] button to exit scan programming.Note:● A zone/ channel cannot be added to the scan list in the following cases.– When it has already been added to the scan list.– When a channel that is not compatible with the Scan Type in the Scan List setting hasbeen selected.● A zone/ channel cannot be deleted from the scan list in the following cases.– When the channel to be deleted is a Priority channel.– When there is no added channel in the scan list.34