Kenwood TK-2180 Modification Information

Also see for TK-2180: Specifications Brochure & specs Instruction manual Instruction manual Service manual

2 CONNECT OPTIONAL DEVICES12 Modification Information Version: 1.13 USA2.3 KDS-100(TK-7180/ 8180 only)You can connect the data terminal (KDS-100) to the TK-7180/ 8180 transceivers to make data communications.This section describes how to connect the KDS-100 tothe TK-7180/ 8180 transceivers.2.3.1 DescriptionThis transceiver can be configured to work with a dataterminal used to perform data transmission. Thistransceiver is equipped with serial input/ output and datamodulation input/ output terminals. FleetSync compatiblemobile transceivers,Kenwood TK-7100/ 8100/ 780/ 880/7150/ 8150/7180/ 8180/ x60G series or etc, support theKDS-100.Also, this KDS-100 is equipped with DSP (Digital SignalProcessing), general purpose serial ports, and generalpurpose I/O ports. Thus, it has been designed to workwith various peripheral devices. Although we provide theFPU (programming software KPG-71D).2.3.2 Features of KDS-100• Full-dot display (240 x 64 dots) with backlight function• A dealer programmable PF keys (ProgrammableFunction Key) with backlight function• The following external terminals are available.- Serial communication terminal- I/ O control terminal- Data modulation I/ O terminals• The following internal terminals are available.- Two general purpose serial ports (compatible withthe RS-232C signal level)- PC/ AT keyboard input terminal (ask R&D )- NMEA0183 GPS receiver connection terminal- Input terminal for differential GPS signal to transferto the GPS equipment.- Two clock synchronizer serial input terminals (forlow-cost card reader) (ask R&D)- General purpose I/O control terminals• DSP for supporting high speed data communication• Real time clock• Battery status memory for data communication• Tri-color LED indicating the communication port status• Modem output level adjustment function using thecommand generated from the electronic volume (PC& Panel Tune)• Firmware update function using a flash ROM• This transceiver supports the following protocols.- Fleet-Sync protocol capable (Non-FleetSynccapable LTR/ Conventional transceivers can be yetinterfaced with FleetSync compatible MDT to work.i.e.TK-*60G)- FleetSync serial protocol 1 (for full FleetSync PCprotocol 1 compatible transceiver. i.e. TK-780/880)- FleetSync serial protocol 2 (for full FleetSync PCprotocol 2 compatible transceiver. i.e. TK-7180/8180)• Internal alarm to notify the message reception• Advanced message function utilizing the FleetSyncShort/ Long Message• PTT ID Display• GPS Auto/Polling capability (Install GPS unit into theKDS-100 or Transciver)• Radio Remote (For PC2 Protocol compatible Radio)• PTT ID Display and Log backup• Emergency Feature Capability (For PC2 protocol)2.3.3 Mechanical Specifications! Product Dimensions and WeightTable 2-8 Product Dimensions and WeightA: Dimension without projectionsB: Dimension including projections! Front Panel• Key Layout: 9-key top set with rubber having LEDbacklight• Display: 240 x 64 positive type full-dot matrix LCDwith LED backlight• LED: Tri-color LED• Pigtail connection cable (15-pin Molex)! Rear Panel• Screw hole for mobile bracket (4 mm screw)• Connector for external devicesItem BodyA BWidth 187 mm 187 mmDepth 42 mm 46.5 mmHeight 88 mm 88 mmWeight 0.50 kg