3 CONNECT THIRD PARTY OPTIONS37 Modification Information Version: 1.13 USA4. Peel off the cover of the tape on the rear surface of theQE-2 board and attach the board in the positionshown in the figure.5. Reinstall the cover and battery pack.3.2.3 Install QE-2 to TK-7180/ 81801. Remove the panel.Unlatch the rear panel by widening two side tabs, usinga flat-head screw driver. Then, pull forward to separatethe front panel from the transceiver body.2. Remove the flat cable from the connector.3. Solder the TX-RX PCB (X57-6930-x0) to the wiresfrom the QE-2 board.You must connect the terminals as shown in thefollowing table.Figure 3-4 Connecting with QE-2 (TK-7180/ 8180)4. Insert the QE-2 board into the position shown in thefigure.5. Insert a flat cable, and install a panel to thetransceiver.CAUTIONREMOVE THE PANEL SLOWLY. OTHERWISE, THE FLATCABLE MAY BE DAMAGED.QE-2 Color TK-7180/8180Terminal nameGNDRXD1TXD1TXD2Man Down Blue RXD2A+ Red OPT1OPT3CH BUSY Violet OPT4Emergency Green OPT5AUX I/O Gray 5EPTT Yellow DTIKEY Brown TCTLTone Ctrl W/Y TXOAUDIHAud Inhib White OPT2Side Tone Orang STONData Out W/B RXEOA- Black TXIRXEIOPT68CCAUTIONDO NOT PEEL OFF THE TAPE COVER THAT HOLDS THEQE-2 BOARD. OTHERWISE, THE QE-2 BOARD MAY NOTBE REMOVED AFTERWARDS.