Kenwood TK-2180 Modification Information

Also see for TK-2180: Specifications Brochure & specs Instruction manual Instruction manual Service manual

3 CONNECT THIRD PARTY OPTIONS35 Modification Information Version: 1.13 USA3.2 ANI BoardYou can install the ANI board to the transceiver. Thissection describes how to install the CIMARRON QE-2 tothe transceiver.Refer to the following URL for the information about theANI board (QE-2).http://www.cimtechcorp.com/qe1manual.pdf! Items Required to Install• Transceiver• QE-2• Adhesive Tape supplied with the QE-2.• Cushion Tape3.2.1 QE-2 Board1. Unplug the QE-2 board from the connector if it isattached.2. Modify and configure the QE-2 board as follows.• Suck and remove the soldering on K.• Solder the position between G and A.• Confirm that G, A, and P are soldered (bridged).3. Configure each signal logic of optional boardaccording to following table.(Refer to 1.2 26-pin Accessory Connector.)Table 3-2 Terminal DescriptionNote: The radio Zone configuration includes Trunking ormixed Trunking and conventional mode, “CH busy”should be configured Transmit Mode as Trunking.Otherwise, when the radio is used underconventional mode only, “CH busy” should beselected “Conventional” for Transmit Mode.We have checked a radio working under followingcondition of QE-2.Transmit Option;• Conventional OnlyTransmit Mode=ConventionalAttack Delay=325mscheck “Busy when Hi”• Trunking and Mix with someTransmit Mode=TrunkingTrunk Select Debounce Time=200mscheck “Trunk Available when Low”PTT Option; check “Key Follow PTT [TOT]”.These setting depend of your system. Please make sureeach timing and configuration consisted your System.CAUTIONYOU MUST TURN THE TRANSCEIVER OFF AND REMOVETHE POWER CABLE BEFORE CONNECTING THE OPTIONINTO THE TRANSCEIVER.KAGLand Name I/O Board Function REMARKSOPT1 O Channel Busy Busy H/ LOK LOPT3 I KEY Active LOPT4 O PTT Active LOPT5 O Emergency Active LOPT2 I Aux I/O Active LGND O V - -SB28C I V + 7.5V typ8.0V typSTON O Sidetone 1kHz 5VppINHAUDIH I Aud Inhib Active L(Mic Mute)DI/ADTI O Data Out 600mVppSTDOPT6 O Man-Down Active LTCNTTCTL I ToneCtl Active H(Tone Sound)