Version: 1.13 USA Modification Information 423 CONNECT THIRD PARTY OPTIONS7. Solder the wires from the Man Down Switch to the TX-RX PCB (X57-6930-x0).Connect the outside wire of the Man Down Switch to“GND” and the center wire to “MDSW”.You must connect the wires to the positions shown inthe following figure.8. Install the Man Down Switch on the position shown inthe figure.9. Fix the Man Down Switch with the protective cloth.10. Reinstall the cover and battery pack.3.3.4 Configuration using KPG-89DYou can configure the Man Down Switch information intothe transceiver using the KPG-89D after installing theswitch.Follow the procedures below to configure the Man DownSwitch information into the transceiver.1. Run KPG-89D.2. Select “Program” > “Read Data from the Transceiver”.You can also click the icon on the Toolbar.The Read Data from the Transceiver window appears.3. Click “Read”.The KPG-89D starts reading the configuration datafrom the TK-2180/ 3180 transceivers.4. Select “Edit” > “Emergency Information”.The Emergency Information window appears.5. Configure the Man Down Switch timing andEmergency information. Refer to the “FPRG 6.14Emergency Information” for details.6. Select “Program” > “Write Data to the Transceiver”. Youcan also click the icon on the Toolbar.The Write Data to the Transceiver window appears.7. Click “Write”.The configuration data having the Man Down Switchinformation will be written to the transceiver.