Version: 1.13 USA Modification Information 383 CONNECT THIRD PARTY OPTIONS3.2.4 Configuration using KPG-89DYou can configure the ANI board information into thetransceiver using KPG-89D after installing the board.Follow the procedures below to configure the ANI boardinformation into the transceiver.1. Run the KPG-89D.2. Select “Program” > “Read Data from the Transceiver”.You can also click the icon on the Toolbar.The Read Data from the Transceiver window appears.3. Click “Read”.The KPG-89D starts reading the configuration datafrom the transceiver.4. Select “Edit” > “Extended Function”.The Extended Function window appears.TK-2180/ 3180 TransceiversTK-7180/ 8180 Transceivers5. Select “ANI Board” from the External Device pull-down menu.Note: Refer to the instruction manual supplied with the ANIBoard for configuration of the ANI Board.6. Select signal as Channel busy of QE-2 from OPT1pull-down menu.When QE-2 board selects “Trunking” for transmitmode via QE-2 E2 programming software, it should beselected LOK., which is signal LTR link is success andpossible to start talking. After this signal changes toLow, PTT ID and Emergency message will betransmitted. Otherwise, selecting “Conventional” fortransmit mode, it should be choose COR or TOR,which is signal the radio is receiving signal and opensquelch. During receiving that signal, QE-2 boardhandles to not start Emergency, Man-Down or PTT IDtransmission.7. Select PTT ID type on Optional Feature window.“Edit > Optional Feature > Common-Page 3”.8. Configure PTT ID sending channel/GID for each.“Edit > Zone Information > Channel/GID Edit”Note; Even if each channel are already selecting PTT ID “On”for FleetSync PTT ID before selecting PTT ID type to“ANI Board”, it will be reset to off when you select ANIBoard for PTT ID type or Optional board selecting.Please confirm it before writing data into the radio.9. Configure Emergency ID on Emergency Information.“Edit > Emergency Information > Emergency ID”All Emergency transmitting and receiving are handledby QE-2 board. Configure the board for Emergencysetup.10. Select “Program” > “Write Data to the Transceiver”.You can also click the icon on the Toolbar.The Write Data to the Transceiver window appears.11. Click “Write”.The configuration data having the ANI boardinformation will be written to the transceiver.