12345678910111213141516171819202142 Connect the transceiver’s DC power connector tothe connector on the DC power cable.• Press the connectors firmly together until the lockingtab clicks.Note:uFor your transceiver to fully exhibit its performance capabilities,the following optional power supply is recommended:PS-33 (20.5 A, 25% duty cycle).uBefore connecting the DC power supply to the transceiver, besure to switch the transceiver and the DC power supply OFF.uDo not plug the DC power supply into an AC outlet until youmake all connections.n Fixed Station OperationIn order to use this transceiver for fixed stationoperation, you will need a separate 13.8 V DC powersupply that must be purchased separately. Therecommended current capacity of your power supply is12 A.1 Connect the DC power cable to the regulated DCpower supply and check that polarities are correct(Red: positive, Black: negative).• DO NOT directly connect the transceiver to anAC outlet!• Use the supplied DC power cable to connect thetransceiver to a regulated power supply.• Do not substitute a cable with smaller gaugewires.Fuse holderBlack (–)Red (+)To AC outletRegulated DC powersupplyFuse holderPressfirmly.