12345678910111213141516171819202134n Changing Call Channel Contents (Split)1 Select the desired band.2 Select the desired receive frequency and relateddata (Tone, CTCSS, DTSS, etc.) using VFO mode orMemory Recall {page 31}.3 Press[F], [CALL] (1 s).• "±" appears.• The channel number is visible if using Memory Recallmode in step 1.4 Turn the Tuning control, or press Mic [UP]/[DWN],to select the desired transmit frequency.5 Press [CALL] again.• The selected transmit frequency is stored in the Callchannel, and the previous mode is restored.Note:uTransmit Offset status and Reverse status are not stored in a splitCall channel.uLockout status is not copied from a memory channel to the Callchannel.MEMORY a VFO TRANSFERTransferring the contents of a memory channel or the Callchannel to the VFO can be useful if you want to search forother stations or a clear frequency, near the selectedmemory channel or Call channel frequency.1 Recall the desired memory channel or the Call channel.2 Press[F], [VFO].• The complete contents of the memory channel or the Callchannel are copied to the VFO. VFO mode is selectedafter the transfer is completed.Note: A transmit frequency from a split memory channel or split Callchannel is not transferred to the VFO. To transfer a transmit frequency,press [REV], then press [F], [VFO].CHANNEL DISPLAY FUNCTIONWhen this function is switched ON, the transceiver displaysonly memory channel numbers instead of frequencies.Press[LOW]+ POWER ON to toggle this function ON orOFF.PWRPWRVOL SQLCALLCALL12
