12345678910111213141516171819202131RECALLING MEMORY CHANNELS1 Select the desired band.2 Press [MR] to enter Memory Recall mode.• The memory channel used last is recalled.3 Turn the Tuning control, or press Mic [UP]/[DWN], toselect the desired memory channel.• Clockwise or Mic [UP]:Increases the channel number.• Counterclockwise or Mic [DWN]:Decreases the channel number.• Empty memory channels cannot be recalled.• To restore the VFO mode, press [VFO].Note:uMemory channels can also be recalled via the microphone keypad.See "Memory Channel Number Entry" {page 75}.uWhen a split memory channel is recalled, "±" appears on the display.Press [REV] to display the transmit frequency.CLEARING MEMORY CHANNELS1 Select the desired band.2 Press [MR] to enter Memory Recall mode.3 Turn the Tuning control, or press Mic [UP]/[DWN], toselect the desired memory channel.4 Switch OFF the power to the transceiver.5 Press [MHz]+ POWER ON.• A confirmation message appears.6 Press [MR] again.• The contents of the selected memory channel are erased.Note: Memory channel 1 cannot be cleared.
