12345678910111213141516171819202179PACKET OPERATIONConnect this transceiver to your personal computer via aTerminal Node Controller (TNC) {page 6}. You can sendEmail to far away stations or obtain a variety of informationvia your local bulletin boards, or you may enjoy otherPacket applications. Reference material for starting Packetoperation should be available at any store that handlesAmateur Radio equipment.ACTIVATING DATA TX/RX BANDIf you prefer, you can send or receive data using a RX-onlyband where “PTT” is invisible. The band with “PTT” is usedfor voice communications.1 Press [MNU] to enter Menu mode.2 Select Menu No. 15 (Data Transfer).3 Press[sssss], then select Item No. 2 (Data Band).4 Press[SET] to toggle the function ON or OFF (default).5 Press [MNU] again to exit Menu mode.• “-Data-” appears for the Data TX/RX band.1200/ 9600 bps OPERATIONSelect 1200 bps or 9600 bps for the data transfer rate,depending on the type of your TNC.1200 bps:The Transmit data input (PKD) sensitivity is 40 mVP-P, andthe input impedance is 10 kΩ. This is suitable for a typical1200 bps TNC.9600 bps:The Transmit data input (PKD) sensitivity is 2 VP-P, and theinput impedance is 10 kΩ. This is suitable for most9600 bps TNCs. Select 9600 bps if using a TNC with dualspeed capability that only has a 2 VP-P output.1 Press [MNU] to enter Menu mode.2 Select Menu No. 15 (Data Transfer).3 Press[sssss], then select Item No. 1 (Data Speed).4 Press[SET] to toggle 1200 bps (default) or 9600 bps.5 Press [MNU] again to exit Menu mode.PWRPWRVOL SQLCALLCALL12PWRPWRVOL SQLCALLCALL12
