12345678910111213141516171819202130STORING DATA IN SIMPLEX CHANNELS1 Select the desired band.2 Select the desired frequency and related data (Tone,CTCSS, DTSS, etc.) using VFO mode, Memory Recall{page 31}, or the Call channel {page 33}.3 Press[F].• A memory channel number and an arrow appear.• The arrow shows whether the current memory channelcontains data ("sssss") or not ("uuuuu").4 Turn the Tuning control, or press Mic [UP]/[DWN], toselect the desired memory channel.5 Press [MR].• The selected frequency and related data are stored in thememory channel. The transmit frequency from a splitmemory channel or split Call channel is not stored.• If the memory channel selected in the previous stepalready contained data, the new data overwrites theprevious data.STORING DATA IN SPLIT CHANNELS1 To select the desired receive frequency, related dataand memory channel, use steps 1 to 4 (not 5) given forSimplex Memory Channels.2 Press [MR] (1 s).• " ± " appears.3 Select the desired transmit frequency.4 Press [MR].• The selected transmit frequency is stored in the memorychannel.Note:uIf you select an offset direction in step 1, you can also press [REV] instep 3 to select a transmit frequency. The transmit frequencyseparated by the current offset frequency will be stored in thememory channel.uIn step 2 you cannot use Mic [MR], or Mic [PF] programmed withMemory Recall.uTransmit Offset status and Reverse status are not stored in a splitmemory channel.