1234567891011121314151617181920219TX-BandPress the left [BAND SEL] (VHF) or the right [BAND SEL](UHF) to select. "PTT" on the display shows which band(VHF or UHF) is currently selected as the transmit (TX)band. You can use the TX band to transmit signals or tocontrol the transceiver.Control BandPress [CONT SEL] to select. On the display "Ctrl" appearsto show which band (VHF or UHF) is currently selected asthe Control band. Use this function when you want tocontrol the band that is not currently used for TX. Afterselecting the Control band, you cannot control the TXband.PWRPWRVOL SQLCALLCALLPWRPWRVOL SQLCALLCALLBUTTON FUNCTION DISPLAYThe lower portion of the display has labels that indicate thecurrent function of each of the 4 front panel buttons. Theitalic font is used to show these 4 buttons in the descriptionof each operation step. After pressing[F] or[F] (1 s),pressing[F] again or waiting for 10 seconds restores thebasic state.Note:uWhen selecting Program Memory mode, you will also see differentlabels. See "Programmable Memory mode" {page 8}.uYou can also select different combinations of button labels. Refer to"CHANGING MULTI-FUNCTION BUTTON LABELS" {page 66}.uAfter pressing [F] or [F] (1 s), press the appropriate key withinapproximately 10 seconds, or the Basic State display will be restored.Labels afterPressing[F] (1 s)Basic StateDisplay LabelsLabels afterPressing[F]sss
