© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | GermanyPhone +49 5251 688865-30 | tech.support (at)malighting.com | www.malighting.comVersion 3.3Time format - swipe button:This is used to set the generated frames per second (FPS). The options are: 24 FPS, 25 FPS, 30 FPS, and 1/100s.Loop - toggle button:When this is active then the generator will jump back to the Start Time (set be the center left encoder) when itreaches the End Time (set by the center right encoder).Jump to Start- also in the title bar of the clock when displaying the timecode slot:This will jump to the Start Time.Rewind:Holding this button will rewind the time.Stop:It stops the generator and sets the time to the Start Time.Pause - also in the title bar of the clock when displaying the timecode slot:This will pause the generator at the current time.Play- also in the title bar of the clock when displaying the timecode slot:Tapping this will start the timecode generator.Fast forward:Holding this button will fast forward the time.Jump to End- also in the title bar of the clock when displaying the timecode slot:This will make the generator jump to the End Time. If loop is active then it will jump back to the Start Time if thegenerator is running.Three of the encoders can be used with the timecode generator. The left encoder does not do anything, but thelabel of the encoder displays the time for the slot. The next encoder can be used to set a Start Time for thegenerator. The third one can be used to set an End Time for the generator.Using command lineThe generator can also be controlled using commands.To play or generate timecode slot 1 use the Go command:[Channel]> Go TimecodeSlot 1Use Off to stop the generator. Pause will pause the generator.34.5. Organize The Show with Multiple Timecode ShowsThis topic has a few tips and tricks when the show contains multiple timecode shows.Separate into songs or sectionsMultiple timecode shows implies this. It is a good idea to separate the performance into smaller sections. If it is for aconcert, then it is an obvious choice to make a timecode show for each song. If it is a theatrical or musicalperformance, then it might be more tricky but there is often obvious time to make separations.For music it might also be a good idea to put each song on separate pages.1150
