© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | GermanyPhone +49 5251 688865-30 | tech.support (at)malighting.com | www.malighting.comVersion 3.313.15. Auto-calibrate fixture positionsThe Auto-calibration is a system where the software positions moving light fixtures based on four makers on the realfloor. This can work, but you and the fixtures needs to be precise.One of the big advantages with having a precise position and rotation of your moving lights is the option to use XYZposition programming.You can access this system using a Stage View and opening the Stage View Options. Here is a tab called"Calibration". In this tab you will find a single button called Calibrate Fixture Pos . Tapping this will open theCalibration pop-up.It could look like this:Calibration pop-up - Absolute ModeThis is separated into a left and a right side.The left side is used to define the markers on the floor.The right side has short description of the workflow in this view. There are also four buttons used to control thecalibration function.The first button is called Find Alternative Flip Solution. This can be used to use a different set of Pan/Tilt values toreach the same point. Moving head fixtures can often hit the same point with up to three different set of values.When the Output Stage Values button is active, then the currently selected fixtures will output the Stage values.Stage values can be edited in the Parameter List, Fixture Types editor and in the Fixture editor.You can use two different modes for the calibration process. One is called Absolute Mode and the other is FreeMode. You can change between the two modes by tapping the Mode button on the right side of the pop-up.699
