Installing and Using Utilities 6-5Express Setup"Express Setup" is intended for initial setup of the server. Its automatic installation mode guides theuser easily through the process by detailing specific hardware features and providing screen promptsfor software selection and configuration. The program loads the utilities and drivers, applies RAIDsettings, partitions the disk, and installs the desired operating system.If you install Windows Server 2003, after a few tasks are completed, all that remains to be done is toremove the NEC EXPRESSBUILDER CD-ROM and install the Windows CD-ROM, input aproduct ID number, and acknowledge the license agreement.IMPORTANT: The Express Setup is intended for the initial setup of the serversystem and, therefore, the Express Setup clears the contents of thehard disk drive. Once Express setup is started, do not remove "ConfigurationDiskette" from the floppy disk drive without any directions. Express Setup does not support the installation of Windows Server2003 x64 Editions.Tools"Tools" is also intended for initial setup of the server. It provides more installation options thanExpress Setup and permits the user to quickly create utility support disks, run the Off-lineMaintenance Utility and system diagnostic utility, set up a maintenance partition, and update thevarious BIOS programs.Tools MenuSave/Restore RAID Configuration DataOff-line Maintenance UtilitySystem DiagnosticsCreate Support DiskSetup Maintenance PartitionBIOS/FW/etc. UpdateRAID Board: NoneServer Management Board:NoneSystem Configuration: NoneSystem ManagementHelpReturn to the Top Menu Save/Restore RAID Configuration DataThe item allows the configuration information on the disk array system to be saved orrestored from the floppy disk.– Save Disk Array Configuration DataThe configuration information on the disk mirroring controller is saved into the floppydisk. If you set or change RAID, always use this function to save the configurationinformation into the floppy disk.IMPORTANT: Some Disk Array Controllers do not support thisfunction. In that case, this menu will not be shown.
