Configuring Your Server 4-7CPUTo check the installed CPU statusSelect [Main] - [Processor Settings] and check the status indications.The on-screen processor numbers and socket locations on the motherboard are associatedas shown in the figure on the previous page.To clear the CPU error informationSelect [Main] - [Processor Settings] - [Processor Retest] – [Yes] and reboot.KeyboardTo set NumlockSelect [Advanced] - [Numlock] – [On]/[Off].Event LogTo clear event logsSelect [Server] - [Event Log Configuration] - [Clear all Event Logs], press Enter, andselect [Yes].SecurityTo set passwords on the BIOSSelect [Security] - [Set Supervisor Password] and enter a password.Select [Security] - [Set User Password] and enter a password.Set Supervisor password first, then User password.External DevicesTo set up external devicesSelect [Advanced] - [Peripheral Configuration] and set up each device.Internal DevicesTo install the disk array controller board or SCSI controller boardSelect [Advanced] - [PCI Configuration] - [PCI Slot n Option ROM] - [Enabled].n: slot numberTo clear the hardware configuration data (after installing/removing internal devices)Select [Advanced] - [Reset Configuration Data] - [Yes].