6-10 Installing and Using UtilitiesStartingThe following two methods are available to start the server. Running NEC EXPRESSBUILDER from the management PC via LAN Running NEC EXPRESSBUILDER from the management PC via direct connection(COM B)For the procedure for starting NEC EXPRESSBUILDER for DOS-based with Remote Console, see"NEC DianaScope".IMPORTANT: Do not change the boot device order in BOOT menu in BIOSSETUP. NEC EXPRESSBUILDER cannot be used if the DVD-ROM drive is not the first device to launch the system. To use the remote console feature, a floppy disk containing aconfiguration information file must be inserted in the floppy diskdrive. You can create a configuration information file by usingSystem Management feature in the Tools menu or by NECDianaScope Configuration menu. The configuration informationfile must be named as "CSL_LESS.CFG" and stored in the rootdirectory of the floppy disk.NOTE: The following items of BIOS setup information will be set asshown below. LAN Controller: [Enabled] Serial Port A: [Enabled]Base I/O Address: [3F8]Interrupt: [IRQ 4] Serial Port B: [Enabled]Base I/O Address: [2F8]Interrupt: [IRQ 3] BIOS Redirection Port: [Serial B] Baud Rate: [19.2K] Flow Control: [CTS/RTS] Console Type: [PC ANSI]