Installing the Operating System with Express Setup 5-25Exceptional SetupThis section explains how to set up the server by the exceptional way. You usually do not have to doas follows. If you want to install the other boards by using a driver floppy disk ("OEM-FD for Massstorage device"), except ones listed in Chapter 5, set the server as follows. The detailed informationis provided by the manual of the Mass storage device.Installation of Mass storage device not to be supported by ExpressSetupIf you want to install the Operating system when the server has new mass storage device not to besupported by NEC EXPRESSBUILDER, follow the steps below.1. Read the manual supplied with the mass storage device before setting the server.2. If the mass storage device is disk array controller, configure the RAID system beforerunning the NEC EXPRESSBUILDER.3. Boot the system from NEC EXPRESSBUILDER CD-ROM.4. (a) When the message "Do you want to use the parameters file..." appears, select "Yes"..(b) When the dialog of Disk array configuration appears, check "Use Existing Array".(c) Check "Apply OEM-FD for Mass storage device".5. Copy the driver for the mass storage device in the ExpressSetup.Insert the floppy disk attached the mass storage device into the floppy disk drive.Continue the ExpressSetup, referring to messages displayed on the display.
