8-14 TroubleshootingFail to access (read or write) to the floppy disk:8 Does the floppy disk drive contain a floppy disk?→ Insert a floppy disk into the floppy disk drive until it clicks.8 Is the floppy disk write-protected?→ Place the write-protect switch on the floppy disk to the "Write-enabled" position.8 Is the floppy disk formatted?→ Use a formatted floppy disk or format the floppy disk in the floppy disk drive.Refer to the manual that comes with the OS for formatting a floppy disk.8 Is BIOS configuration correct?→ The floppy disk drive may be disabled with the BIOS SETUP utility of the server.Check the setting with the BIOS SETUP utility.[Main] - [Floppy A][Security] - [Diskette Write Protect]8 Is the server in the Secure Mode?→ In the Secure Mode, write access to the floppy disk may be disabled. To releasethe Secure Mode, enter the password specified with the BIOS SETUP utility.Fail to access to the CD-ROM:8 Is the CD-ROM properly set in the CD-ROM drive tray?→ The tray is provided with a holder to secure the CD-ROM. Make sure that theCD-ROM is placed properly in the holder.8 Is the CD-ROM applicable to the server?→ The CD-ROM for Macintosh is not available for use.8 Is the flex bay installed correctly?→ Reinstall the flex bay (see Chapter 9).Inserted the correct CD-ROM but the message like the following is displayed:The CD-ROM is not inserted or the wrong CD-ROM is inserted.Please insert the correct CD-ROM.OK8 Is the data side of the CD-ROM dirty or injured?→ Take the CD-ROM out of the CD-ROM drive, confirm that it is not dirty orinjured, reset and click [OK].
