5-32 Installing the Operating System with Express SetupInstalling the Windows 2000Express Setup proceeds the setup by specifying the necessary information on the wizard. You canalso save the setup information created on the wizard in a floppy disk as a setup file.NOTE: Prepare a floppy disk to use as Configuration Disk if youwant to save the parameters or use the drivers located on the"OEM-Disk for Mass Storage Device" that ships with optional boards.When using the floppy disk, the Express setup can continue the setupwithout specifying the parameters.1. Turn the power of peripheral device on, and then turn on the server.NOTES: If you operate installing Windows 2000 with MO device connected,the installation may not be completed normally. In such case,detach MO device and then re-install the system from thebeginning. Connect the hard disk drive that OS is not going to be installedafter installing OS. If you create multiple logical drives in your system, refer to"Reinstalling the operation system when multiple logical drivesexist" (Appendix D).2. Insert NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.3. Press Ctrl, Alt, and Delete to reboot from the NEC EXPRESSBUILDER.The system boots from the CD-ROM and NEC EXPRESSBUILDER starts.4. Click [Express Setup].5. The message, "Do you want to use the parameters file in order to set up the Express serveror workstation ?", appears.If you want to use the parameters file, click [Yes].If not, click [No].
