8-30 Troubleshooting5. When the following message is displayed, press S.Setup could not determine the type of one or more mass storage devicesinstalled in your system, or you have chosen to manually specify an adapter.Currently, Setup will load support for the following mass storage devices.The following message is displayed.Please insert the disk labeledmanufacturer-supplied hardware support diskinto Drive A:*Press ENTER when ready.6. Insert the Windows 2000 OEM-DISK for NEC EXPRESSBUILDER into the floppy diskdrive, and press Enter.A list of mass storage devices is displayed.SCSI Model: Select the [Adaptec Ultra320 SCSI Cards (Win2000)] and press Enter.Then, it returns to the screen of Procedure 5.7. Select the proper SCSI Adapter and press Enter.– Adaptec HostRAID U320 Driver Ver 1.02 For Windows 2000/XP/2003 (When SCSIHostRAID is installed.)– MegaRAID SCSI 320-1 Controller Driver (When N8103-80F board is installed.)– MegaRAID SCSI 320-2 Controller Driver (When N8103-81F board is installed.)– Adaptec I2O RAID Driver Disk for 32bit Windows 2000/XP/2003 (When N8103-86board is installed.)8. Press R to select the recovery option.9. If you are requested, press R to select system recovery procedure.10. If you are requested, select either of the procedure below:[Manual Recovery] (Press M)Do not select this option unless you are a high-level user or a system administrator.If you use this option, you can recover the problems of system files, partition bootsector, and start-up environment.[Quick Recovery] (Press F)This option is very easy to use and the user does not need to do anything during theprocedure. If you select this option, the system recovery disk program starts torecover the problems concerning system files, partition boot sector of system disk,and start-up environment (if multiple operating systems are installed on the system).
