Appendix E E-15Installing RAID Controller Driver (N8103-80F/81F)To additionally install the N8103-80F/81F in a system containing Windows 2000, connect thecontroller and take the following steps to install the driver:1. When the [Found New Hardware Wizard] dialog box appears, click [Next].2. When the [Install Hardware Device Drivers] dialog box appears, select [Search for asuitable driver for my device (Recommended)], and click [Next].3. When the [Locate Driver Files] dialog box appears, select [Floppy disk drives], insert"Windows Server 2000 OEM-DISK for NEC EXPRESSBUILDER" into the floppy diskdrive, and click [Next].4. When the [Driver Files Search Results] dialog box appears, click [Next].5. Copying of the driver is completed, and the [Completion of the new hardware detectionwizard] dialog box below appears. Click [Complete].Available Switch Options for Windows 2000 Boot.ini FileMany different switches will be available if you edit Boot.ini File.For the available switch options, refer to the following information: Microsoft Knowledge Base - Article ID: 170756"Available Switch Options for the Windows NT Boot.ini File"If your system has a memory capacity in excess of 4GB in its installing, adding /PAE switch inBoot.ini file will enable the system to be installed with over 4GB of memory.However, the Microsoft operating system products which support /PAE switch option are limited.Refer to the following article in Microsoft Knowledge Base to check the supported products. Microsoft Knowledge Base - Aritcle ID: 291988"A description of the 4GB RAM tuning feature and the Physical Address Extensionswitch"
