4-4 Configuring Your ServerConfiguration ExamplesThe following describes examples of configuration required to use software-link features or forsystem operations.Link with Management SoftwareTo link with the temperature monitoring feature of NEC ESMPRO AgentSelect [Server] - [Thermal Sensor] - [Enabled].To control power supply of the server with NEC ESMPRO Manager via the networkSelect [Advanced] - [Advanced Chipset Control] - [Wake On Lan] - [Enabled].Select [Server] - [AC-LINK] - [StayOff].UPSTo link power supply with the UPS To power on the server when power is supply from the UPSSelect [Server] - [AC-LINK] - [Power On]. To keep the server off-powered even when power is supplied from the UPS if the POWERswitch was used to power offSelect [Server] - [AC-LINK] - [Last State]. To keep the server off-powered even when power is supplied from the UPSSelect [Server] - [AC-LINK] - [StayOff].BootTo change the boot order of devices connected to the serverSelect [Boot] and specify the boot order.To display POST check resultsSelect [Advanced] - [Boot-time Diagnostic Screen] - [Enabled].You can also press Esc while the NEC log is on the screen to display POST check results.To control from the HW consoleSelect [Server] - [Console Redirection] and set each item.
