General Description 2-7Rear ViewSee Chapter 8 for detail information on lamp indication.1 AC inlet 1The AC inlet 1 is connected with the power cord coming with the server.2 AC inlet 2The AC inlet 2 is used when the additional power supply unit is installed in the server.3 ICMB-1 (left) ICMB-2 (right) connectorThe ICMB connector is connected to a device having the ICMB interface.4 Serial port B connectorThe serial port B connector is used to connect the server to a device with the serial interface.The server cannot be directly connected to a leased line through the connector.For using this port, the rear serial cable that comes with your server should be connected tothis connector.5 External SCSI connectorThe external SCSI connector is used to connect the server to external SCSI devices. For theconnection, attached SCSI cable is necessary and some cable connections must be changedon the baseboard.6 PCI slot power lamp (green) (upper)The PCI slot power lamp is lit when the power of the PCI slot being on.6 PCI slot fault lamp (amber) (lower)PCI slot fault lamp blinks when the hot plug PCI function is enabled with Windows 2000. Thelamp also goes on if a fault occurs in the PCI board installed into the slot or the slot itself.7 Printer port connectorThe printer port connector is connected with a printer with the Centronics interface.1 2 3-1 3-2 4 5 6789 10 11 1213-117 18 17 19 212014 15 1613-2
