2-6 General DescriptionFront View (Switches and Lamps)See Chapter 8 for detail information on lamp indication.1 Serial port B connectorThe serial port B connector is used to connect the server to a device with the serial interface.The server cannot be directly connected to a leased line through the connector.IMPORTANT: Only the RJ-45 serial interface cable can be connected to this port. Do notconnect any other interface cables such as the Ethernet cable. Doing so could damage thedevice, your server, or both.2 USB3 connectorThe USB3 connector allows the server to be connected to a device accepting the USBinterface.3 SLEEP switchPressing the sleep switch once causes the server to enter into the sleep state (power savingmode). Pressing the power switch in the sleep state recovers the machine to the normalstate. (This function is supported by Windows 2000.)4 UID (Unit ID) switchPressing the UID switch turns UID lamp (blue) located on the front panel and the rear panel onand off. The UID lamp located on the rear panel is visible through the rear of the chassis andallows you to locate the server you're working on from the rear of the servers on a rack.5 UID lamp (blue)Lights in blue when the ID switch is pressed.6 RESET switchThe reset switch is used to reset the server.7 POWER/SLEEP lamp (green)Lights in green when the server is powered on. Goes off when the server is powered off.Blinks when the system is placed in the sleep mode.8 POWER switchThe power switch is used to turn on/off the power. If you press the switch once, then thePOWER/SLEEP lamp goes on and the power is turned on. If you press the switch again, thepower is turned off. The system is forcibly shut down when the power switch is pressedcontinuously for four seconds or longer.9 Dump switchThe dump switch is used to collect the event logs having occurred in the server.10 STATUS lamp (green/amber)Lights in green while the server is in successful operation. When any error is detected, thislamp lights or blinks in amber.11 LAN1/LAN2 ACCESS lamp (green)Lights in green while the server is connected to the network. Blinking in green indicates thenetwork activity. Numbers printed near the lamps indicate the LAN port number.12 DISK ACCESS lamp (green/amber)Lights in green while the internal hard disk is in access. When any one of the internal harddisks fails, this lamp lights in amber.1 2 3 4 5 6 7 89 10 11 11 12
