Motorola Netopia® Router CLI Commands 2-121index: 1 = primary server; 2 = alternate serverhost: IP address or DNS hostname of serversecret: RADIUS or TACACS+ shared secrettacacs-plus accounting [ yes | no ]This command enables or disables TACACS+ accounting.IP Filterset Configuration CommandsNote: Beginning with firmware version 8.2, the force-route and force-route-gateway attributes have beenadded for policy-based routing, and the tos and tos-mask attibutes have been added for TOS field matching.The CLI for filters is fairly complex. More explanation follows the command itself.compare-op = { nc | ne | <> | lt | < | le | <= | eq | = | ge | >= | gt | > }port-compare = { nc | { compare-op digits } }filter-id = { 1..255 | new | last }IP Filterset Configuration Commandsip filterset fs-tag {in | out} [filter] filter-id [enable {yes | no}][forward {yes | no} | [ force-route {yes | no ] force-route-gateway ip-addr}]][{ call-placement | idle-reset } { no-change | disabled }][source { ip-addr/mask-bits | ip-addr mask }][destination { ip-addr/mask-bits | ip-addr mask }][ tos { tos_value tos-mask tos_mask_value } |[ protocol { 1..65535 |any |gre |{ {tcp | 6 } [{source port-compare}] [{destination port-compare}][established | all] } |{ {udp | 17 } [{source port-compare}] [{destination port-compare}]} |{ {icmp | 1 } [{type port-compare}] [{code port-compare}]} } ]no ip filterset fs-id [{in | out} [filter-id ]]show ip filterset fs-id [{in | out} [filter-id ]]
