2-58 Command Line Interface Commands ReferencePVCsNote: The commands in this section are supported beginning with firmware release 8.3.1.interface { adsl | sdsl } id pvc { id | tag }no interface { adsl | sdsl } id pvc { id | tag }show interface { adsl | sdsl } id pvc { id | tag }These commands allow you to set, disable, or show a permanent virtual circuit. You can specify an optionalcircuit tag of up to 14 ASCII characters. The tag is used only to identify the circuit for management purposes,and has no significance on the wire; it is merely a convenience to aid in selecting circuits from lists. The defaultcircuit name is “Circuit ”, where is replaced with a single decimal ASCII digit (between one and eight)corresponding to the circuit’s position in the list of up to eight circuits.taginterface { adsl | sdsl } id pvc { id | tag } tag tagshow interface { adsl | sdsl } id pvc { id | tag } tagThese commands allow you to set or show a permanent virtual circuit identified by tag.PVC Configuration Commandsinterface { adsl | sdsl } id pvc { id | tag }no interface { adsl | sdsl } id pvc { id | tag }show interface { adsl | sdsl } id pvc { id | tag }interface { adsl | sdsl } id pvc { id | tag } tag tagshow interface { adsl | sdsl } id pvc { id | tag } taginterface { adsl | sdsl } id pvc { id | tag } enable { yes | no }no interface { adsl | sdsl } id pvc { id | tag } enableshow interface { adsl | sdsl } id pvc { id | tag } enableinterface adsl id pvc { id | tag } qos { ubr | cbr | vbr }show interface adsl id pvc { id | tag } qosinterface { adsl | sdsl } id pvc { id | tag } vpi vpi-valshow interface { adsl | sdsl } id pvc { id | tag } vpiinterface { adsl | sdsl } id pvc { id | tag } vci vci-valshow interface { adsl | sdsl } id pvc { id | tag } vciinterface { adsl | sdsl } id pvc { id | tag } cp { profile-id | profile-tag | default }show interface { adsl | sdsl } id pvc { id | tag } cp