Motorola Netopia® Router CLI Commands 2-43Generic WAN Interface configuration commandsNote: For possible values of intf-type, refer to “Interface Naming Conventions” on page 1-3. Generic WANInterface Commands may be applied to any router WAN interface by specifying the intf-type wan together withthe appropriate interface id. Alternatively, you can specify the more specific intf-type if you choose.interface intf-type id dle { hdlc | ppp [{vcmux | vcmultiplexed | llcsnap}] |rfc1483 [{ bridged | routed }] | rfc1490 }show interface intf-type id dleThese commands allow you to set or show the global data link encapsulation type of the interface specified byintf-type id. At this time you can generally think of the data link encapsulation of interface 1 as the global datalink encapsulation of the router itself.Note: atmfuni is accepted as a synonym for rfc1483 and frame-relay is accepted as a synonym for rfc1490.For ppp, the default mode is vcmux. For rfc1483, the default mode for frame-based SDSL (R7100) interfacesis bridged, while the default mode for cell-based SDSL (R7200) interfaces is routed.Example:interface wan 1 dle frame-relayGeneric WAN Interface Configuration Commandsinterface intf-type id dle { hdlc | ppp [{vcmux | vcmultiplexed | llcsnap}] |rfc1483 [{ bridged | routed }] | rfc1490 }show interface intf-type id dleshow interface intf-type id statisticsshow interface intf-type id statsshow interface wan id statusinterface wan 0 tracking { yes | no }Restricted WAN Interface Configuration Commandsinterface { adsl | ethernet | isdn | sdsl } id pppoe enable { yes | no }no interface { adsl | ethernet | isdn | sdsl } id pppoe enableshow interface { adsl | ethernet | isdn | sdsl } id pppoe enableinterface { adsl | sdsl } id pvc { id | tag } { yes | no }interface { adsl | sdsl } id pvc { id | tag } pcr numshow interface { adsl | sdsl } id pvc { id | tag } pcr
