3-22 Command Line Interface Commands Referencecp { name | index } ip state-insp xposed-list xposed-list_nameno cp { name | index } ip state-insp xposed-listshow cp { name | index } ip state-insp xposed-listThese commands allow you to set, disable, or show the status of a stateful inspection exposed address list forthe specified Connection Profile. Exposed address lists are similar to NAT server lists. Exposed addresses inthe list will not be subject to stateful inspection and hence unsolicited inbound traffic will be allowed to theseaddresses.These are active only if NAT is disabled on the profile.cp { name | index } ip state-insp tcp-seq-diff diffshow cp { name | index } ip state-insp tcp-seq-diffThese commands allow you to set or show TCP sequence difference acceptable for the specified ConnectionProfile.cp { name | index } ip state-insp router-access { yes | no | on | off }no cp { name | index } ip state-insp router-accessshow cp { name | index } ip state-insp router-accessThese commands allow you to set, disable, or show the status of default mapping to router for the specifiedConnection Profile.cp { name | index } ip state-insp deny-frag { yes | no | on | off }no cp { name | index } ip state-insp deny-fragshow cp { name | index } ip state-insp deny-fragThese commands allow you to set, disable, or show whether fragmented packets are received for the specifiedConnection Profile.L2TP Connection Profile Configuration CommandsNote: The commands in this section are supported beginning with Firmware Version 8.2.cp { name | index } l2tp ip partner ip-addrshow cp { name | index } l2tp ip partnerThese commands allow you to specify or show the partner Ipv4 address associated with the local L2TP tunnel.cp { name | index } l2tp ip via ip-addrshow cp { name | index } l2tp ip viaThese commands allow you to specify or show a gateway address at which the partner address may be reachedwhen the partner IP and the remote IP addresses are on the same subnet.cp { name | index } l2tp authentication enable { yes | no }show cp { name | index } l2tp authentication enableThese commands allow you to enable, disable or show the status of L2TP CHAP-like tunnel authentication forthe specified profile.