Motorola Netopia® Router CLI Commands 2-85Stateful Inspection CommandsSee also:■ “Stateful Inspection Configuration Commands” on page 2-32 for Ethernet interface commands, and■ “Stateful Inspection Commands” on page 3-21 for Connection Profile commands.Note: The commands in this section are supported beginning with Firmware Version 8.2.ip state-insp udp-timeout valueshow ip state-insp udp-timeoutThese commands allow you to specify or show the UDP timeout value for the stateful inspection feature. TheUDP timeout range is between 30 and 65535 seconds.ip state-insp tcp-timeout valueshow ip state-insp tcp-timeoutThese commands allow you to specify or show the TCP timeout value for the stateful inspection feature. TheTCP timeout range is between 30 and 65535 seconds.ip state-insp dos-detect [ yes | no ]show ip state-insp dos-detectNote: These commands are supported beginning with Firmware Version 8.7.These commands allow you to set or show the status of Denial of Service (DoS) detection in the statefulinspection feature. Packets are monitored for DoS attack detection if this option is set to yes. Offendingpackets maybe discarded if it is determined to be a DoS attack.ip state-insp xposed-addr { [server-list-tag start-ip-addr end-ip-addr] }{ [protocol start-port end-port] }no ip state-insp xposed-addr { [server-list-tag] }show ip state-insp xposed-addr abcThese commands allow you to add an entry to the specified list, or, if list does not exist, create the list for thestateful inspection feature. Accepted values for protocol are tcp, udp, or both. The show command allows youto display exposed entries in the list specified by the tag. The no command removes all addresses in the listand deletes the list.
