142 Configuring a 2350 Switch for a Branch Office320656-ADisplaying and Saving the ConfigurationThe 2350 immediately implements configuration changes by updating the device’s running configuration.However, the software does not automatically retain configuration changes after a software reboot or a powercycle. To review and save configuration changes, use the following commands:show configsave configVerifying OperationThe following sections describe how to verify IP connectivity between the 2350 and other devices in thenetwork, and how to verify wireless user sessions.21. Authentication \authorization rules To use the local database to authenticate and authorize network accessto an encrypted SSID by Microsoft 802.1X clients:set authentication dot1x ssid ssid-name ** [bonded]peap-mschapv2 localTo use the local database to authenticate and authorize networkaccess to an unencrypted SSID by WebAAA clients:set authentication web ssid ssid-name ** localshow aaaThe * and *.* values are wildcards that match on any username. (Forinformation, see the “User Wildcards, MAC Address Wildcards, andVLAN Wildcards” section in the “Using the Command-Line Interface”chapter of the Nortel WLAN 2300 System Software ConfigurationGuide.)Note: To use a RADIUS server group to authenticate access, specifythe server group name instead of local. (You also can specify a servergroup name and local, in either order, to provide a backup method.)(For the syntax to authenticate MAC or last-resort users, see the“Configuring AAA for Network Users” chapter of the Nortel WLAN2300 System Software Configuration Guide.To configure authentication rules for administrative access, see the“Configuring AAA for Administrative and Local Access” chapter ofthe same guide.)Table 12: Configuration Parameter List (continued)ConfigurationParameters CLI Commands